Delta M125HV - Internal Fan 2

5.4.4 Internal Fan 2
Figure 5-22: Internal Fan 2 location
Figure 5-21: Remove the internal fan 2 shield cover
* Screw torque required for
assembling: 2 N•m
When used, the AC side compartment is provisioned with a single fan module.
(See Figure 5-21, 5-22, 5-23, 5-24)
If the warning "Fan Fail- Internal F01" show on the DSS / APP, please follow
the procedure below to remove Internal Fan 2.
(1) Remove the shield cover.
(shown in Figure 5-21)
(2) Remove the two screws shown in Figure 5-22.
(3) Disconnect the fan power connector.
(4)
Lift the entire fan assembly from the left compartment. (shown in Figure 5-23)
(5) Clean assembly or replace with a new fan. (shown in Figure 5-24)
(6) Reassemble using a tightening torque of 2 N•m.
77
Maintenance