Delta PCS100 - Powering off the PCS100

Maintenance
Maintenance Manual 18
Powering off the PCS100
To power off the system, see the following guidelines:
1. Check the system status on the front display panel to ensure that the system is not in a SoftS-
tart or Run state.
2. If the system is in SoftStart or Run state, push the PCS OFF button on PCS HMI Tool to switch
the PCS system to Standby mode.
Figure 14. PCS HMI Tool - PCS ON/OFF Control
3. Turn the AC and DC switches on the front door to the OFF state as shown in Figure 15.
Figure 15. Disengaging the AC and DC Switches (OFF State)
ON
AC DISCONNECT
OFF
ON
DC DISCONNECT
OFF
ON
AC DISCONNECT
OFF
ON
DC DISCONNECT
OFF