Delta PCS100 - Switch Indicator for Door State (Door Sensor)

Maintenance
Maintenance Manual 64
Installing a G Board
1. Align the posts on the front door with the keyholes on the G board.
2. Slide the G board to lock in place.
3. Secure the G board with screws.
4. Connect the cables to the L board.
Figure 83. Installing a G Board
5. Close the front door. See “Closing a Front Door” on page 22.
Switch Indicator for Door State (Door Sensor)
WARNING!
Read the “Safety Instructions” on page ix on the first at the beginning of this manual before
performing any service on the components. Ignoring safety instructions may result in injury,
damage or death.
CAUTION!
DANGEROUS VOLTAGE LEVELS MAY BE PRESENT FOLLOWING DISCONNECTION. DO NOT OPEN THE
CABINET UNTIL A REASONABLE PERIOD OF TIME HAS ELAPSED.
D
EATH, SERIOUS INJURY, OR HARDWARE DAMAGE CAN RESULT IF CAUTION IS NOT TAKEN.
!
!