Maintenance
Maintenance Manual 67
3. Align one end of the wires to the holes on door sensor.
4. Secure the wires with washers and screws.
Figure 87. Installing the Wires
5. Close the front door. See “Closing a Front Door” on page 22.
DC Fuse
Read the “Safety Instructions” on page ix on the first at the beginning of this manual before
performing any service on the components. Ignoring safety instructions may result in injury,
damage or death.
DANGEROUS VOLTAGE LEVELS MAY BE PRESENT FOLLOWING DISCONNECTION. DO NOT OPEN THE
CABINET UNTIL A REASONABLE PERIOD OF TIME HAS ELAPSED.
D
EATH, SERIOUS INJURY, OR HARDWARE DAMAGE CAN RESULT IF CAUTION IS NOT TAKEN.
!