Delta PCS100 - Auxiliary Heat Exchanger Power Board (G Board)

Maintenance
Maintenance Manual 62
Installing a LCD Module
1. Situate the LCD module over the L plate. Take note of the terminal block socket and connector.
2. Install the bolts and LCD module.
3. Secure the LCD module with screws.
Figure 81. Installing an LCD Module
4. Install the L board. See “Installing an L Plate” on page 60.
5. Close the front door. See “Closing a Front Door” on page 22.
Auxiliary Heat Exchanger Power Board (G Board)
WARNING!
Read the “Safety Instructions” on page ix on the first at the beginning of this manual before
performing any service on the components. Ignoring safety instructions may result in injury,
damage or death.
CAUTION!
DANGEROUS VOLTAGE LEVELS MAY BE PRESENT FOLLOWING DISCONNECTION. DO NOT OPEN THE
CABINET UNTIL A REASONABLE PERIOD OF TIME HAS ELAPSED.
D
EATH, SERIOUS INJURY, OR HARDWARE DAMAGE CAN RESULT IF CAUTION IS NOT TAKEN.
!
!