Delta PCS100 - IGBT Driver Board (B Board)

Maintenance
Maintenance Manual 116
3. Align the hole on the wires with the holes on the DC softstart relay.
4. Secure the wires with screws.
Figure 167. Installing the Wires
5. Connect the cable.
Figure 168. Connecting the Cable
6. Installing a safety cover. See “Installing a Safety Cover” on page 37.
7. Close the front door. See “Closing a Front Door” on page 22.
IGBT Driver Board (B Board)
WARNING!
Read the “Safety Instructions” on page ix on the first at the beginning of this manual before
performing any service on the components. Ignoring safety instructions may result in injury,
damage or death.
CAUTION!
DANGEROUS VOLTAGE LEVELS MAY BE PRESENT FOLLOWING DISCONNECTION. DO NOT OPEN THE
CABINET UNTIL A REASONABLE PERIOD OF TIME HAS ELAPSED.
D
EATH, SERIOUS INJURY, OR HARDWARE DAMAGE CAN RESULT IF CAUTION IS NOT TAKEN.
!
!