Maintenance
Maintenance Manual 37
14. Locate the DC extension rod and the hex screw on the side of the extension rod, see the follow-
ing figure.
15. Insert a hex-key wrench and remove the hexagon screw. This allows the extension rod to be
free from the securing slot.
16. Gently pull the DC extension rod straight out.
17. Remove the DC extension rod.
Figure 44. Removing the DC Extension Rod
Installing a Safety Cover
1. Starting with the DC extension rod, align the base of the rod to the socket. The base of the rod is
design to fit on the socket in a specific alignment.
2. Insert the hexagonal screw in the screw hole on the rod and turn it to thread it in place.
3. Insert a hex-key wrench in the screw and turn it to secure the rod to the socket.
Figure 45. Installing a DC Extension Rod
To Next Page
Loading...
