Maintenance
Maintenance Manual 47
Installing AC and DC Switch Handles
1. Open the front door. See “Opening a Front Door” on page 20.
2. Starting from the exterior side of the front door, locate the socket housing for the handles and
align the handles to match the housing orientation.
3. Once aligned correctly, insert the handles through the housing. Make sure the handles are not
tilted or skewed to one side when inserting.
4. Push the handles in until the seal at the base of the handle is flush with the front door.
Figure 60. Installing AC and DC Switch Handles
5. Make sure the handles are seated correctly in place then locate the inner side of the front door.
The socket housing is located at the bottom of the front door (inner side).
6. For the next step, it may be necessary to have a second individual hold the handle in place from
the exterior of the front door. Insert the screws and tighten them to secure the switch handles to
the front door.
Figure 61. Securing AC and DC Switch Handles to the Front Door
7. Before closing the front door, inspect the switch handles from the exterior of the front door.
There shouldn’t be a gap between the handle base and the front door. In addition, if the handle
shakes slightly, it is not tightened correctly. Re-install the handles to ensure they are installed
correctly.
8. Close the front door. See “Closing a Front Door” on page 22.
ON
AC DISCONNECT
OFF
ON
DC DISCONNECT
OFF
To Next Page
Loading...
