Maintenance
Maintenance Manual 87
6. Push down on the top of the DC SPD release tab with your finger. As the DC SPD releases, lift
the bottom of the DC SPD.
7. Remove the DC SPD from the rail.
Figure 112. Removing a DC SPD
Installing a DC SPD
1. Position the rear of the DC SPD directly in front of the rail. Make sure the top of the DC SPD
hooks over the top of the rail, as shown in the following illustration.
2. Once the DC SPD is seated correctly in the rail clip, press the front of the DC SPD to rotate the
DC SPD down and into the release tab on the DC SPD.
If seated correctly, the bottom of the rail should be fully inserted in the release tab.
Figure 113. Installing a DC SPD
To Next Page
Loading...
