Delta SA180 - Machine Use; Typical Operation

17
TYPICAL OPERATIONS
The us e of atta ch ments and
accessoires not recommended by Delta may result in
risk of injury.
The following are some of the many operations that can
be performed with your Delta Disc Sander.
Sharpening a cold chisel on the belt unit with the table
tilted.
Sanding aluminum on the disc unit with or without the
table tilted and using the miter gage as a guide. NOTE:
Always sand on the left (downward) side of the sanding
disc, as shown. Sanding on the right (upward) side of
the sanding disc could cause the workpiece to fly up,
which could be hazardous.
Sanding outside curves on the belt unit with the platen.
Sharpening a wood chisel on the belt unit using a block
of wood to support the chisel and provide clearance for
the chisel handle.
Fig. 35
Fig. 36
Fig. 37
Fig. 38
MACHINE USE