Delta VFD007FP4EA-41 - Page 177

Chapter 11 Summary of Parameter SettingsCFP2000 Series
11-3
Pr.
Explanation
Settings
Factory
Setting
Bit 2: Reserved
Bit 3: Reserved
00-20
Source of Master Frequency
Command（AUTO）
0: Digital keypad
1: RS-485 serial communication
2: External analog input (Pr.03-00)
3: External UP/DOWN terminal
6: CANopen communication card
8: Communication card (no CANopen card)
0
00-21
Source of the Operation Command
（AUTO）
0: Digital keypad
1: External terminals. Keypad STOP disabled.
2: RS-485 serial communication. Keypad STOP
disabled.
3: CANopen communication card
5: Communication card (no CANopen card)
0

00-22
Stop Method
0: Ramp to stop
1: Coast to stop
0

00-23
Control of Motor Direction
0: Enable forward/reverse
1: Reverse disable
2: Forward disable
0
00-24
Memory of Digital Operator
(Keypad) Frequency Command
Read only
Read
only

00-25
User Defined Characteristics
Bit 0~3: user defined decimal place
0000b: no decimal place
0001b: one decimal place
0010b: two decimal place
0011b: three decimal place
Bit 4~15: user define on unit
000xh: Hz
001xh: rpm
002xh: %
003xh: kg
004xh: m/s
005xh: kW
006xh: HP
007xh: ppm
008xh: 1/m
009xh: kg/s
00Axh: kg/m
00Bxh: kg/h
00Cxh: lb/s
00Dxh: lb/m
00Exh: lb/h
00Fxh: ft/s
010xh: ft/m
011xh: m
012xh: ft
013xh: degC
014xh: degF
015xh: mbar
016xh: bar
017xh: Pa
018xh: kPa
019xh: mWG
01Axh: inWG
01Bxh: ftWG
01Cxh: psi
01Dxh: atm
01Exh: L/s
01Fxh: L/m
020xh: L/h
021xh: m3/s
022xh: m3/h
0