Delta VFD007FP4EA-41 - Page 185

Chapter 11 Summary of Parameter SettingsCFP2000 Series
11-11
Pr.
Explanation
Settings
Factory
Setting

02-21
Reserved

02-22
Desired Frequency Attained 1
0.00~599.00Hz
60.00/
50.00

02-23
The Width of the Desired
Frequency Attained 1
0.00~599.00Hz
2.00

02-24
Desired Frequency Attained 2
0.00~599.00Hz
60.00/
50.00

02-25
The Width of the Desired
Frequency Attained 2
0.00~599.00Hz
2.00
02-32
Brake Delay Time
0.000~65.000 sec.
0.000

02-33
Output Current Level Setting for
Multi-function External Terminals
0.00~655.35%
0

02-34
Output frequency setting
for multi-function output
terminal
0.00~599.00Hz（Motor speed when using PG Card）
0.00

02-35
External Operation Control
Selection after Reset and
Activate
0: Disable
1: Drive runs if run command exists after reset
0

02-47
~
02-49
Reserved
02-50
Status of Multi-function Input
Terminal
Monitor the status of multi-function input terminals
Read
only
02-51
Status of Multi-function Output
Terminal
Monitor the status of multi-function output terminals
Read
only
02-52
Display External Output terminal
occupied by PLC
Monitor the status of PLC input terminals
Read
only
02-53
Display External Multi-function
Output Terminal occupied by
PLC
Monitor the status of PLC output terminals
Read
only
02-54
Display the Frequency
Command Executed by External
Terminal
0.01~599.00Hz (Read only)
Read
only
02-55
Reserved
02-56
Reserved
02-57
MO: Erase Current Level
0.00~655.35%
0.00
02-58
Brake Detection Frequency
0.00~3.00Hz
0.00
02-70
IO Expansion Card ID Parameter
0~7
Read
only
02-71
Reserved
02-72
Preheating Output Current Level
0~100%
0
02-73
Preheating Output Cycle
0~100%
0