Delta VFD007FP4EA-41 - Page 308

Chapter 12 Description of Parameter Settings|CFP2000 Series
12.1-06-13
Output Frequency at Malfunction
Factory Setting: Read only
Settings 0.00~655.35Hz
 When malfunction occurs, use can check the current frequency command. If it happens
again, it will overwrite the previous record.
Output Voltage at Malfunction
Factory Setting: Read only
Settings 0.0~6553.5V
 When malfunction occurs, user can check current output voltage. If it happens again, it will
overwrite the previous record.
DC Voltage at Malfunction
Factory Setting: Read only
Settings 0.0~6553.5V
 When malfunction occurs, user can check the current DC voltage. If it happens again, it will
overwrite the previous record.
Output Current at Malfunction
Factory Setting: Read only
Settings 0.0~6553.5Amp
 When malfunction occurs, user can check the current output current. If it happens again, it will
overwrite the previous record.
IGBT Temperature at Malfunction
Factory Setting: Read only
Settings
-3276.7~3276.7℃
 When malfunction occurs, user can check the current IGBT temperature. If it happens again, it
will overwrite the previous record.
Capacitance Temperature at Malfunction
Factory Setting: Read only
Settings
-3276.7~3276.7℃
 When malfunction occurs, user can check the current capacitance temperature. If it happens
again, it will overwrite the previous record.
Motor Speed in rpm at Malfunction
Factory Setting: Read only
Settings -32767~32767 rpm
 When malfunction occurs, user can check the current motor speed in rpm. If it happens again, it
will overwrite the previous record.
Reserved