Chapter 12 Description of Parameter SettingsMS300 (High Speed Model)
12-11-1
11 Advanced Parameters This parameter can be set during operation.
In this parameter group, ASR is the abbreviation for Adjust Speed Regulator.
System Control
Factory Setting: 0
Settings bit 3: Dead time compensation closed
bit 7: Selection to save or not save the frequency
bit 7 = 0: frequency is saved before power turns off. When power turns ON again, the displayed
frequency will be the memorized frequency.
bit 7 = 1: frequency is not saved before power turns off. When power turns ON again, the
displayed frequency will be 0.00 Hz.