49
4
5
Once “Meters” or “Feet” is selected in step 3, the
Delay Time screen appears automatically.
Select the speaker to be set.
The picture of the speaker selected blinks.
6
Set the distance between the center speaker and listening position.
The distance changes in units of 0.03 meters (0.1 foot) or 0.3 meters (1 foot) each time the
button is pressed. Select the value closest to the measured distance.
If “Yes” is selected for “Default”, the settings are automatically reset to the default values.
When “Step” is selected, you can select the unit of “0.1 m (1 ft)” or “0.01 m (0.1 ft)”.
Please note that the difference of distance for every speaker should be 6.0 m (20 ft) or less. If
you set an invalid distance, a CAUTION notice, such as screen right will appear. In this case,
please relocate the blinking speaker(s) so that its distance is no larger than the value shown in
highlighted line.
Example: When the distance is set to 3.6 m
for the center speaker
7
Enter the setting.
The Speaker Setup menu reappears.
The AVC-A1XV automatically sets the optimum
surround delay time for the listening room.
To Next Page
Loading...
