ENGLISH
26
Basic Operation Basic Operation
ENGLISH
• When making parameter settings, the display will return to the
regular condition several seconds after the last button was
pressed and the setting will be completed.
5
Press the ENTER button to finish the surround
parameter mode.
• DEFAULT setting
Select “YES” to reset to the factory defaults.
2 Operating the surround mode and the surround
parameters from the main unit’s panel
1
Turn the SELECT knob to select the surround
mode.
When turned clockwise:
2
Press and hold in the SURROUND PARAMETER
button to select the parameter you want to set.
The parameters which can be set differ for the different
surround modes are displayed. (Refer to “Surround modes
and parameters” ( page 40).)
When turned counterclockwise:
To select the surround mode while adjusting the surround
parameters, tone defeat or tone control, press the
SURROUND MODE button, then operate the selector.
2 Surround parameters r
ROOM SIZE:
This sets the size of the sound field.
There are five settings: “small”, “med.s” (medium-small),
“medium”, “med.l” (medium-large) and “large”. “small”
recreates a small sound field, “large” a large sound field.
EFFECT LEVEL:
This sets the strength of the surround effect.
The level can be set in 15 steps from 1 to 15. Lower the level
if the sound seems distorted.
DELAY TIME:
The delay time can be set within the range of 0 to 110 ms only
in the matrix mode.
TONE CONTROL:
This can be set individually for each surround mode except
DIRECT.
3
Display the parameter you want to adjust, then
turn the SELECT knob to set it.
• When making parameter settings, the display will return to the
regular condition several seconds after the last button was
pressed and the setting will be completed.
To Next Page
Loading...
Need help?
General
