Denon AVR-1612 - Page 53

38
C
SB
SL
SR
IN
L
L
FL
FR
SW
Power amplifier
6.1-channel (Surround back speaker) connection
If using only one surround back speaker (with a 6.1-channel connection),
connect to the “L” side of the SURR. BACK/FRONT HEIGHT terminal.
For speaker settings in this case, see “When 6.1ch (Surround back
speaker) installed” (vpage35).
To perform 6.1-channel playback using the surround back speaker,
set “Pre Assign” to “NORMAL” in steps 3 and 4 for “Set up “Pre
Assign”” (vpage40).
Also use the “Speaker Config.” setting (vpage 59) to set
“S.Back” to “1spkr”.
NOTE
•A power amplifier (sold separately) is required for this connection.
•For speaker cable connections, see C page 6 “Connecting the
speakers”.
•For speaker impedance, see page36.
Connect
Basic version
Advanced version
Information
Advanced version