Denon AVR-1712 - Playback (Basic Operation) - Input Source; Important Information Before Playback; Selecting the Input Source; Using the Source Select Menu

7
ENGLISHDEUTSCHFRANÇAISITALIANOESPAÑOLNEDERLANDSSVENSKA
Preparation PlaybackSetup Wizard
7
ENGLISHDEUTSCHFRANÇAISITALIANOESPAÑOLNEDERLANDSSVENSKA
Playback (Basic operation)
Here, we explain how to perform simple operations.
For details, see the included CD-ROM (Owner’s manual).
Important information
Before starting playback, make the connections between the different
devices and the settings on the unit.
NOTE
Also refer to the operating instructions of the connected devices
when playing them.
Selecting the input source
Press the input source select button
(
BD, SAT/CBL, TV, DVD, V.AUX,
DOCK, TUNER, GAME1, GAME2 or
CD) to be played back.
The desired input source can be selected
directly.
tIf the input source select button (TUNER, BD, SAT/CBL, TV,
GAME 1/2, DVD, DOCK, CD, V.AUX) on the main unit is pressed,
the same function as with the remote control unit can be obtained.
tWhen
iPod 1 on the main unit is pressed, the input source of this
unit is switched to “DOCK” and the connected iPod is automatically
played (vm page 24 “iPod play function”).
You can also use the following operation to select an input
source.
Using the “Source Select” menu
Switch the remote control unit to the J (MAIN ZONE) mode when
performing this operation (vm page 74 “Operating AV device”).
If the remote control unit is in
K (ZONE2) mode, the “Source
Select” menu will not be displayed when
SOURCE SELECT is
pressed.
Player
BD
DVD
CD
DOCK
Video
SAT/CBL
TV
GAME1
GAME2
V.AUX
Tuner
TUNER
[ENTER] Enter[ ] Move
Source Select
The currently selected input
source is highlighted.
q Press SOURCE SELECT.
Display the “Source Select” menu.
w Use uio p to select the input source,
then press
ENTER.
The input source is set and the source
selection menu is turned off.
tInput sources that are not going to be used can be set ahead of time.
Make this setting at “Source Delete” (vm page 65).
tTo turn off the source selection menu without selecting an input
source, press
SOURCE SELECT again.
tWhen
SOURCE SELECT is pressed, the AMP-operation mode starts
automatically (vm page 74).
Selecting the input source