Name: Denon AVR-1906
Brand: Denon
Rating: 5 (1 reviews)

To Next Page

To Previous Page

ENGLISH

Connecting Other Sources Connecting Other Sources

• Use these terminals if you wish to connect external power amplifier(s) to increase the power of

the front, center, surround and surround back sound channels, or for connection to powered

loudspeakers.

• When using only one surround back speaker, connect it to the left channel.

Connecting the pre-out terminals

Power amplifier

SURROUND

BACK

SURROUND

FRONT

CENTER

SUB-

WOOFER

Connecting the power supply cord

AC 120 V, 60 Hz

AC outlets (Wall)

NOTE:

• Only use the AC OUTLETS for connecting audio equipment. Never use it for hair driers, TVs

or other electrical appliances.

AC OUTLETS

•SWITCHED (total capacity – 120 W (1 A.))

The power to these outlets is turned on and

off in conjunction with the POWER switch on

the main unit, and when the power is

switched between on and standby from the

remote control unit.

No power is supplied from these outlets

when this unit’s power is at standby. Never

connect equipment whose total power

consumption exceeds 120 W (1 A.).

Other manuals for Denon AVR-1906

Questions and Answers:

Need help?

Do you have a question about the Denon AVR-1906 and is the answer not in the manual?

Power Amplifier Section

front power output (8 ohms)	85 W + 85 W
front power output (6 ohms)	120 W + 120 W
center power output (8 ohms)	85 W
center power output (6 ohms)	120 W
surround power output (8 ohms)	85 W + 85 W
surround power output (6 ohms)	120 W + 120 W
surround back power output (8 ohms)	85 W + 85 W
surround back power output (6 ohms)	120 W + 120 W

Preamplifier Section

input sensitivity/impedance	200 mV/47 kohms
output level/load impedance	SUBWOOFER 1.2 V/10 kohms
frequency response	10 Hz - 100 kHz (+1, -3 dB)
signal-to-noise ratio	98 dB (IHF-A weighted)
tone control treble	±12 dB at 10 kHz
tone control bass	±12 dB at 100 Hz

FM Section