Denon AVR-4311

135
Basic versionSimple version Advanced version
ENGLISH
Information
Specifications
n Audio section
• Power amplifier
Rated output: Front:
140 W + 140 W (8 Ω, 20 Hz – 20 kHz with 0.05 % T.H.D.)
170 W + 170 W (6 Ω, 1 kHz with 0.7 % T.H.D.)
Center:
140 W (8 Ω, 20 Hz – 20 kHz with 0.05 % T.H.D.)
170 W (6 Ω, 1 kHz with 0.7 % T.H.D.)
Surround:
140 W + 140 W (8 Ω, 20 Hz – 20 kHz with 0.05 % T.H.D.)
170 W + 170 W (6 Ω, 1 kHz with 0.7 % T.H.D.)
Surround back:
140 W + 140 W (8 Ω, 20 Hz – 20 kHz with 0.05 % T.H.D.)
170 W + 170 W (6 Ω, 1 kHz with 0.7 % T.H.D.)
Front height / Front wide:
140 W + 140 W (8 Ω, 20 Hz – 20 kHz with 0.05 % T.H.D.)
170 W + 170 W (6 Ω, 1 kHz with 0.7 % T.H.D.)
Dynamic power: 150 W x 2ch (8 Ω)
220 W x 2ch (4 Ω)
Output connectors: 4 – 16 Ω
• Analog
Input sensitivity/Input impedance: 200 mV/47 kΩ
Frequency response: 10 Hz – 100 kHz — +1, –3 dB (DIRECT mode)
S/N: 102 dB (IHF–A weighted, DIRECT mode)
Distortion: 0.005 % (20 Hz ~ 20 kHz) (DIRECT mode)
Rated output: 1.2 V
• Digital
D/A output: Rated output — 2 V (at 0 dB playback)
Total harmonic distortion — 0.008 % (1 kHz, at 0 dB)
S/N ratio — 102 dB
Dynamic range — 100 dB
Digital input: Format — Digital audio interface
• Phono equalizer (PHONO input — REC OUT)
Input sensitivity: 2.5 mV
RIAA deviation: ±1 dB (20 Hz to 20 kHz)
S/N: 74 dB (A weighting, with 5 mV input)
Rated output: 150 mV
Distortion factor: 0.03 % (1 kHz, 3 V)
n Video section
• Standard video connectors
Input/output level and impedance: 1 Vp-p, 75 Ω
Frequency response: 5 Hz – 10 MHz — +0, –3 dB (when “Video Convert” set to “OFF”)
• Color component video connector
Input/output level and impedance: Y (brightness) signal — 1 Vp-p, 75 Ω
P
B / CB signal — 0.7 Vp-p, 75 Ω
P
R / CR signal — 0.7 Vp-p, 75 Ω
Frequency response: 5 Hz – 60 MHz — +0, –3 dB (when “Video Convert” set to “OFF”)
n Tuner section [FM] [AM]
(Note: μV at 75 Ω, 0 dBf = 1 x 10
–15
W)
Receiving Range: 87.5 MHz – 108.0 MHz 522 kHz – 1611 kHz
Usable Sensitivity: 1.2 μV (12.8 dBf) 18 μV
50 dB Quieting Sensitivity: MONO 2.0 μV (17.3 dBf)
STEREO 42 μV (34.5 dBf)
S/N (IHF-A): MONO 72 dB
STEREO 67 dB
Total harmonic Distortion (at 1 kHz): MONO 0.3 %
STEREO 0.7 %
n General
Power supply: AC 230 V, 50 Hz
Power consumption: 780 W
0.1 W (Standby)
2.2 W (CEC standby)
Maximum external dimensions: 434 (W) x 171 (H) x 414 (D) mm
Weight: 17.3 kg
n Main remote control unit (RC-1145)
Batteries: R6/AA Type (two batteries)
Maximum external dimensions: 53 (W) x 224 (H) x 30 (D) mm
Weight: 178 g (including batteries)
n Sub remote control unit (RC-1148)
Batteries: R03/AAA Type (two batteries)
Maximum external dimensions: 49 (W) x 220 (H) x 24.5 (D) mm
Weight: 114 g (including batteries)
For purposes of improvement, specifications and design are subject to change without notice.
1.AVR4311E2_ENG_6th_0810.indd 135 2010/08/12 10:12:26