0
Getting Started Connections Settings Playback Remote ControlMulti-zone Information Troubleshooting SpecificationsRemote Control
ENGLISH
Operating the Main Remote Control Unit
With some remote control units, the signals cannot be learned or the
device will not operate properly even when the signals have been
learned. In this case, use the device’s own remote control unit.
Learned buttons have priority over the preset memory. If you no
longer need the learned setting, reset the learning function (vpage
107).
•
•
NOTE
[POWER ON], [POWER OFF] and [SOURCE SELECT] cannot be
learned.
Do not learn any remote control signals at [RC SETUP].
The MAIN, ZONE2, ZONE3, ZONE4 and MACRO modes cannot be
learned.
Codes cannot be learned at [MASTER VOLUME] or [MUTE] when the
main remote control unit is set to “TUNER”, “NET/USB” or “iPod”.
•
•
•
•
Calling out
1
Press [MAIN], to select “MACRO”.
2
Press [MACRO] (1 ~ 3) at which the signals were
registered.
The registered signals are transmitted in the registered
sequence.
This function lets you register a series of operations at a single
button.
For example, the amplifier can be turned on, the input source selected,
the monitor’s power turned on, the source device’s power turned on
and the play mode set all by pressing a single button.
Up to 32 signals each can be registered at [MACRO] (1 ~ 3).
MACRO Function
1
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
2
Press [9], [7] and [8], in that order.
The signal transmission indicator flashes twice and the system
call registration mode is set.
3
Press [MACRO] (1 ~ 3) at which you want to register
the signals.
4
Press the buttons you want to register in the same
sequence as the operations you want to perform.
The signal transmission indicator lights when a button is
pressed.
Example : Press [POWER ON].
↓
Press [DEVICE SELECTOR] – [DVD/HDP].
↓
Press [1].
The mode can be switched by pressing [DEVICE SELECTOR].
Perform the registration procedure for all the buttons you want
to register.
b
b
5
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice and the setting
is completed.
NOTE
Registration is not possible in ZONE2, ZONE3, ZONE4 and MACRO
modes.
Registering
To Next Page
Loading...
Need help?
General
Weight and Dimensions
