125
Quick Select Names
Change the “Quick Select” display title to one you prefer.
Setting details
Quick Select 1 / Quick Select 2 / Quick Select 3 / Quick Select 4
•Up to 16 characters can be input.
•For character input, see page99.
Set Defaults : The input source name is returned to the default setting.
•Reset : Reset to the defaults.
•Cancel : Do not reset to the defaults.
If you select “Set Defaults” and press ENTER, the message “Reset all
Quick Select names to the factory defaults?” is displayed. Select “Reset” or
“Cancel”, and then press ENTER.
Auto Standby
Default settings are underlined.
When you do not perform any operation on this unit with no audio or video input for a specified time,
this unit automatically enters the standby mode. Before it enters the standby mode, “Auto Standby” is
displayed on the display of this unit and the menu screen.
Setting details
60 min : The unit goes into standby after 60 minutes.
30 min : The unit goes into standby after 30 minutes.
O : The unit does not go into standby automatically.
Front Display
Default settings are underlined.
Makes settings related to the display on this unit.
Setting items Setting details
Dimmer
Adjust the display
brightness of this unit.
Bright : Normal display brightness.
Dim : Reduced display brightness.
Dark : Very low display brightness.
O : Turns the display o.
Buttons on the main unit can be used for operations.
Each time DIMMER is pressed, the setting is changed as shown
below.
Bright Dim
DarkOff
NOTE
When “Dimmer” is set to “O”, the display turns o and appears as if
there is no electricity.
General
To Next Page
Loading...
Need help?
General
