27
Check Results
This function enables you to check the measurement results and equalizer characteristics after Audyssey
®
Setup.
1
Press SETUP to display the menu on the TV screen.
2
Use u to select “Speakers” – “Audyssey
®
Setup” and then press ENTER or p.
3
Use i to select “Check Results” and then press ENTER.
Audyssey Setup
Channel Select
Amp Assign
Check Results
Restore...
Start
Your AV receiver can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
Check Results
Distances
Levels
Crossovers
Speaker Config.
Equalizers
Check Audyssey Setup Measurement results.
4
Use ui to select the item you want to check, then press ENTER.
Measurement results for each speaker are displayed.
Speaker Config.
Check the speaker configuration.
Distances
Check the speaker distance.
Levels
Check the speaker channel level.
Crossovers
Check the speaker crossover frequency.
Equalizers
Check the equalizer.
•If “Equalizers” is selected, press
ui to select equalizing curve (“Audyssey” or “Audyssey Flat”) to
be checked.
Use ui to switch the display between the dierent speakers.
5
Press o or BACK.
The confirmation screen reappears. Repeat step 2.
Retrieving Audyssey
®
Setup settings
If you set “Restore...” to “Restore”, you can return to Audyssey
®
Setup measurement result (value
calculated at the start by MultEQ
®
) even when you have changed each setting manually.
Set up speakers (Audyssey® Setup)
Making the network settings
(Network)
This unit can be connected to a home network (LAN) to listen to Internet Radio or play back music files and
still image (JPEG) files stored on a computer.
1
Connect the Ethernet cable (vpage19 “Connecting to a home network (LAN)”).
2
Turn on this unit (vpage28).
This unit performs automatic network setup due to the DHCP function.
When connecting to a network that has no DHCP function, perform the setting in “Settings”
(vpage121).
To Next Page
Loading...
Need help?
General
