124
General
Language
Default settings are underlined.
Set the language for display on the menu screen.
Setting details
English / Français / Español
“Language” can also be set by the following procedure. However, the menu screen is not displayed.
Following the display content to make the setting.
1. Press and hold the main unit’s ZONE2 SOURCE and STATUS for at least 3 seconds.
“< NTSC >” appears on the display.
2. Press the main unit’s DIMMER and set “< ENGLISH >”.
3. Use the main unit’s SOURCE SELECT 0 1 and set the language.
4. Press the main unit’s STATUS to complete the setting.
ZONE2 Setup
Default settings are underlined.
Set the audio to play back with multi-zone (ZONE2).
Setting items Setting details
Lch Level
Adjust the left channel
output level.
–12dB – +12dB (0dB)
Rch Level
Adjust the right channel
output level.
–12dB – +12dB (0dB)
Volume Level
Set the volume output level.
Variable : Volume adjustment is enabled by main unit and remote control
unit.
1 – 98 (–79dB – 18dB) : The volume is adjusted to the set level.
Volume Limit
Make a setting for
maximum volume.
60 (–20dB) / 70 (–10dB) / 80 (0dB)
O : Do not set a maximum volume.
This is displayed from –79 dB to 18 dB when “Scale” (vpage104)
is set to “–79.5dB – 18.0dB”.
Setting items Setting details
Power On Volume
Define the volume setting
that is active when the
power is turned on.
Last : Use the memorized setting from the last session.
Mute : Always mute when power is turned on.
1 – 98 (–79dB – 18dB) : The volume is adjusted to the set level.
This is displayed from –79 dB to 18 dB when “Scale” (vpage104)
is set to “–79.5dB – 18.0dB”.
Mute Level
Set the amount of
attenuation when muting
is on.
Full : The sound is muted entirely.
–40dB : The sound is attenuated by 40 dB down.
–20dB : The sound is attenuated by 20 dB down.
Zone Rename
Change the display title of each zone to one you prefer.
Setting details
MAIN ZONE / ZONE2
•Up to 10 characters can be input.
•For character input, see page99.
Set Defaults : The input source name is returned to the default setting.
•Reset : Reset to the defaults.
•Cancel : Do not reset to the defaults.
If you select “Set Defaults” and press ENTER, the message “Reset all zone
names to the factory defaults?” is displayed. Select “Reset” or “Cancel”,
and then press ENTER.
To Next Page
Loading...
Need help?
General
