Denon AVR-E400 User Manual

94
Sleep timer function
•This is convenient for viewing and listening while going to sleep in
ZONE2.
•The sleep timer function can be set by zone.
1
Press ZONE2 to switch the zone
mode.
ZONE2 lights.
2
Press SLEEP and display the time
you want to set.
•The time switches as shown below each time SLEEP is pressed.
Off 10 min 20 30 40 50
6080 7090100
110
120
To confirm the countdown time before putting the
unit to sleep
Press SLEEP.
“Z2 Sleep : zmin” appears on the display.
z Countdown time
To cancel the sleep timer
Press SLEEP to set “O”.
The sleep timer is also cancelled when this unit is set to the standby
mode or the ZONE2 power is turned o.
NOTE
The sleep timer function cannot turn o the power of devices
connected to this unit. To turn o the power of those connected
devices, set up sleep timers on the connected devices themselves.
Basic instructions
Advanced instructions
Information
Advanced instructions
DVD

Denon AVR-E400 Specifications

General

HDMI Inputs	6
HDMI Outputs	1
3D Pass-through	Yes
4K Pass-through	Yes
Dolby TrueHD	Yes
DTS-HD Master Audio	Yes
Audyssey MultEQ	Yes
Network Connectivity	Yes
AirPlay	Yes
DLNA	Yes
Input Impedance	47 kOhms
Input Sensitivity	200 mV
Signal-To-Noise Ratio	100 dB
Response Bandwidth	10 Hz - 100 kHz
THD	0.08%
Tuner Presets	56
Tuner Bands	AM/FM
Frequency Response	10 Hz - 100 kHz
Video Upscaling	Yes
Bluetooth	No
Wi-Fi	No
Surround Sound Effects	DTS Neo:6
Audio D/A Converter	192kHz/24-bit
Inputs	HDMI, Digital Optical, Digital Coaxial, Analog
Outputs	HDMI, Headphones