EasyManuals Logo

Denon AVR-E400 User Manual

Denon AVR-E400
159 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
22
2
Set up the subwoofer
If using a subwoofer capable of the following
adjustments, set up the subwoofer as shown below.
For details, see your subwoofer’s manual.
n When using a subwoofer with a direct mode
Set the direct mode to “On” and disable the volume adjustment
and crossover frequency setting.
n When using a subwoofer without a direct mode
Make the following settings:
•Volume : “12 o’clock position”
•Crossover frequency : “Maximum/Highest Frequency”
•Low pass filter : “O”
•Standby mode : “O”
3
Set up the zone mode
Press MAIN to switch the zone mode.
MAIN lights.
Press MAIN
1
Prepare the included Setup and
measurement microphone
Mount the Setup and measurement microphone on
a tripod or stand and place it in the main listening
position.
When placing the Setup and measurement microphone, adjust
the height of the sound receptor to the level of the listener’s
ear.
Sound receptor
Setup and
measurement
microphone
If you do not have a tripod or stand, set up the microphone on, for
example, a seat without a back.
NOTE
•Do not hold the Setup and measurement microphone in your hand
during measurements.
•Avoid placing the Setup and measurement microphone close to a
seat back or wall as sound reflections may give inaccurate results.
Set up speakers (Audyssey® Setup)
4
Connect the Setup and measurement microphone to
the SETUP MIC jack of this unit.
Audyssey Setup
Channel Select
Amp Assign
Check Results
Restore...
Start
Your AV receiver can automatically measure the acoustics of
your room then optimize your speakers using the included
microphone.
Set the following items
if necessary.
When the Setup and
measurement microphone is
connected, the following screen is
displayed.
•Here, we explain setup using the example of 5.1-channel speaker
playback.
For settings other than 5.1-channel speaker playback, select
“Amp Assign” and perform step 3 to 6 of “Set up “Amp Assign””
(vpage86).
If unused channels are set with “Channel Select”, measuring time
can be shortened. For setting, perform steps 7 to 11 of “Set up
“Channel Select”” (vpage87).
Preparation
Basic instructions
Advanced instructions
Information
Basic instructions
v See overleaf
DVD

Table of Contents

Other manuals for Denon AVR-E400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-E400 and is the answer not in the manual?

Denon AVR-E400 Specifications

General IconGeneral
HDMI Inputs6
HDMI Outputs1
3D Pass-throughYes
4K Pass-throughYes
Dolby TrueHDYes
DTS-HD Master AudioYes
Audyssey MultEQYes
Network ConnectivityYes
AirPlayYes
DLNAYes
Input Impedance47 kOhms
Input Sensitivity200 mV
Signal-To-Noise Ratio100 dB
Response Bandwidth10 Hz - 100 kHz
THD0.08%
Tuner Presets56
Tuner BandsAM/FM
Frequency Response10 Hz - 100 kHz
Video UpscalingYes
BluetoothNo
Wi-FiNo
Surround Sound EffectsDTS Neo:6
Audio D/A Converter192kHz/24-bit
InputsHDMI, Digital Optical, Digital Coaxial, Analog
OutputsHDMI, Headphones

Related product manuals