Denon AVR-S730H Troubleshooting Guide

Description “V1-02”: Cannot detect the HDMI signal from the source device at
the AVR input terminal (as TMDS Rx PLL UnLock).
Description “V1-06”: Copyright Protection certification Error with Source
Device. (HDCP Error).
Description “V1-10”: Quality of HDMI Signal(TMDS) is bad.
Note 1 : Source Device check item (For details (v p. 40))
Note 2 : AV Receiver check item (For details (v p. 40))
Introduction How to operate Cable Test Limit mode Log & EDID Troubleshooting
24

Denon AVR-S730H Specifications

General

Channels	7.2
Power Output (6 ohm, 1 kHz, 0.7% 2ch Drive)	110W
Power Output (6 ohm, 1 kHz, 10% 1ch Drive)	165W
HDMI Inputs	6
HDMI Outputs	1
Dolby Atmos	Yes
DTS:X	Yes
DTS Virtual:X	Yes
Wi-Fi	Yes
Bluetooth	Yes
HEOS Multi-room	Yes
4K Ultra HD Pass-through	Yes
HDR Support	Yes (HDR10, Dolby Vision, HLG)
Auto Speaker Calibration	Audyssey MultEQ
AirPlay	Yes (AirPlay 2)
Internet Radio	Yes
Phono Input	No
Ethernet Port	Yes
Power Output per Channel	75W (8 ohm, 20Hz-20kHz, 0.08% 2ch Drive)
USB Input	1 (Front)