Denon AVR-S900W User Manual

Video
Make video-related settings.
Picture Adjust
Picture quality can be adjusted.
0
Can be set when the “Video Conversion” setting is “On”.
(v
p. 159)
0
Can be set when “HDMI”, “COMP” or “VIDEO” is assigned for each input source.
(v p. 165)
0
“Contrast”, “Brightness”, “Saturation”, “Noise Reduction” and “Enhancer” can be
set when “Picture Mode” is set to “Custom”.
0
“Picture Adjust” settings are stored for each input source.
0
“Picture Adjust” cannot be set when 4K signals are input.
o
Picture Mode
Select the desired picture mode according to the video content and
your viewing environment.
Standard:
The standard mode suited for most living room viewing
environments.
Movie:
A mode suited for watching movies in a dark room such
as a theater room.
Vivid:
A mode that makes graphic images for games, etc.
brighter and more vivid.
Streaming: A mode suited for low bit rate video sources.
Custom: Adjusts the picture quality manually.
Off: No picture quality adjustment is done with this unit.
Contents Connections Playback Settings Tips Appendix
152
Front panel Display Rear panel Remote Index

Denon AVR-S900W Specifications

General

Channels	7.2
HDMI Inputs	8
HDMI Outputs	2
Wi-Fi	Yes
Bluetooth	Yes
4K Ultra HD Pass-through	Yes
Dolby Atmos	Yes
DTS:X	No
HDMI Pass-Through	Yes
Input Impedance	47 kOhm
Input Sensitivity	200 mV
THD at rated output	0.08%
Signal-To-Noise Ratio	98 dB
DAC Resolution	24-bit / 192kHz
HDMI Switching	Yes
AirPlay	Yes
DLNA	Yes
Dimensions	17.1 x 6.6 x 13.3 inches
Power Output	90 W
Response Bandwidth	10Hz-100kHz
Output Impedance / Channel	6 Ohm
Inputs	HDMI
Outputs	HDMI
Supported Audio Formats	MP3, WMA, AAC, FLAC, WAV
Supported Video Formats	4K
Output Power / Channel	90W (8 ohms, 20Hz-20kHz, 0.08% THD)