Denon AVR-X2200W Service Manual

3.6. Operation Info Mode
3.6.1. Actions
This mode enables the unit to display the accumulated operating time, power on count and each protection count.
3.6.2. Starting up
AVR-X2200W
· While holding down buttons "
ZONE2 SOURCE
", "
DIMMER
" and "
STATUS
" simultaneously, press the power button to
turn on the power.
AVR-S910W
· While holding down buttons "
TUNER PRESET CH+
", "
TUNE -
" and "
PRESET +
" simultaneously, press the power but-
ton to turn on the power.
Select the "4. OP INFO" using the "
TUNER PRESET CH+ / -
" button, then press the "
STATUS
" button to conrm.
3.6.3. Operations
Press the "
STATUS
" button after starting up this device in Operation Info mode.
The following information is displayed in the following order.
(a) Accumulated operating time
FLD
O P T i m e H
↑ Time display
"
STATUS
"
(b) Power on count
FLD
P . O n T i m e
↑ Count display
"
STATUS
"
(c) DC / ASO Protection count
FLD
D C : / A S O :
"
STATUS
"
(d) Thermal Protection (A/B) count
FLD
T H M A : / B :
"
STATUS
"
(e) Thermal Protection (E/F) count
FLD
T H M E : / F :
"
STATUS
"
(f) Thermal Protection count
FLD
C u r r e n t :
"
STATUS
"
(Returns to normal display)
52

Denon AVR-X2200W Specifications

General

Channels	7.2
HDMI Inputs	8
HDMI Outputs	2
Dolby Atmos	Yes
DTS:X	Yes
Wi-Fi	Yes
Bluetooth	Yes
4K Ultra HD Pass-through	Yes
Audyssey MultEQ XT	Yes
HDCP Support	2.2
AirPlay	Yes
Ethernet	Yes
Phono Input	Yes
Total Harmonic Distortion	0.08% (20Hz-20kHz)
HDMI Version	2.0a
4K Support	Yes
HDR Support	Yes
Dimensions (W x H x D)	434 x 167 x 339 mm
Power Output per Channel	95W (8 ohms, 20Hz - 20kHz, 0.08% THD)
USB Input	1
Frequency Response	10Hz - 100kHz
Inputs	8 HDMI, 2 component
Outputs	2 HDMI, 1 composite, 1 component