Denon AVR-X4100W

Initializing registered preset codes
1
Press and hold down MAIN and OPTION until the DEV,
TV and AVR indicators on the remote are flashing
green, then release.
Specifying the operating zone with the
remote control
To prevent accidental misuse, you can set the zone for which the remote
control unit is used.
1
Press and hold down either MAIN, Z2 or Z3 and SETUP
at the same time until the DEV., TV and AVR indicators
flash green.
MAIN: When only using MAIN ZONE
Z2: When using MAIN ZONE and ZONE2
Z3
(Default):
When using MAIN ZONE, ZONE2 and
ZONE3
Resetting the remote control unit
All the settings are restored to their defaults.
1
Press and hold down DEVICE MENU until the DEV, TV
and AVR indicators on the remote are flashing green,
then release.
2
Press 9, 8 and 1, in that order.
The DEV., TV and AVR indicators flash twice.
All the settings are restored to their defaults.
Contents Connections Playback Settings Tips Appendix
261
Front panel Display Rear panel Remote Index