Using the keyboard screen
1
Display the screen for inputting characters.
GExampleH “Source Rename” screen
.
2
Use uio p to select ,
or ..
3
Press ENTER to move the cursor to the character that
you wish to change.
0
Each time ENTER is pressed, the cursor moves by one
character.
4
Select a character to be input with uio p
then press
ENTER.
5
Repeat steps 2 - 4 to change the name.
6
Use uio p
to select “OK”, then press ENTER.
Using the number buttons
1
When the keyboard screen is displayed, press 0 – 9.
The 10 key input screen is displayed.
2
Place the cursor at the character to be changed with
o p and press the number button (0 – 9) until the
desired character is displayed.
0
The types of characters that can be input are as shown below.
.
3
Repeat step 2 to change the name then press ENTER to
register it.
Contents Connections Playback Settings Tips Appendix
181
Front panel Display Rear panel Remote Index