o
Power does not turn on / Power is turned off
Symptom Cause / Solution Page
Power does not turn on.
0
Check whether the power plug is correctly inserted into the power outlet. 80
Power automatically turns
off.
0
The sleep timer is set. Turn on the power again. 162
0
“Auto Standby” is set. “Auto Standby” is triggered when there is no operation for a set amount of time. To
disable “Auto Standby”, set “Auto Standby” on the menu to “Off”.
261
Power turns off and the
power indicator flashes in
red approx. every 2
seconds.
0
The protection circuit has been activated due to a rise in temperature within this unit. Turn the power off,
wait about an hour until this unit cools down sufficiently, and then turn the power on again.
330
0
Please re-install this unit in a place having good ventilation. －
Power turns off and the
power indicator flashes in
red approx. every 0.5
seconds.
0
Check the speaker connections. The protection circuit may have been activated because speaker cable
core wires came in contact with each other or a core wire was disconnected from the connector and
came in contact with the rear panel of this unit. After unplugging the power cord, take corrective action
such as firmly re-twisting the core wire or taking care of the connector, and then reconnect the wire.
40
0
Turn down the volume and turn on the power again.
82
0
This unit’s amplifier circuit has failed. Unplug the power cord and contact our customer service center. －
The power to this unit does
not turn off when you press
the Power operation
button. “ZONE2 On” or
“ZONE3 On” appears on
the display.
0
Power in either ZONE2 or ZONE3 is on. To turn off the power of the device (standby), press either the
ZONE2 ON/OFF or ZONE3 ON/OFF button on the main unit, or press the POWER X button after
pressing the Z2 or Z3 button on the remote control to turn off the power of ZONE2 or ZONE3.
－
Contents Connections Playback Settings Tips Appendix
282
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
Weight and Dimensions
