2
Before use
Part names and
functions
Connections
Basic
operations
Installing and setting up
supplied software
USB settings
Troubleshooting Index
Specifications
Signal system chart Before use
Main features
1. Reliable design
•High grade steel cabinet and self-illuminating rubber buttons.
•Equipped with a LINE TO MASTER function that enables backup
ifthecomputerfreezes,orwhenswitchingusers(vpage11).
2. USB MIDI controller
•Equipped with a physical controller function that controls DJ
software.
•DesignlayoutoptimizedforoperationswithTRAKTORLE2/PRO2
andVirtualDJLE/PRO.
•Easy operations for video effect and video cross fader settings in
VirtualDJLE/PRO.
•Equipped with a deck layer function that can control four decks
separately.
•Equipped with a high resolution jog wheel with 2,048 pulses
supporting the touch sensor function.
•Sampler can be controlled without switching the deck layer.
•EquippedwithlargeCUE/PLAYbuttonsthatcanbepressedeasily.
•EquippedwiththeSYNCbuttonthatcanimmediatelysynchronize
beats for two decks.
•Separate FX controls for individual decks.
3. USB AUDIO interface
•High sound quality design that supports sampling frequency of 48
kHz.
•Supports stereo 2in-2out for stereo audio.
•Supplied with ASIO drivers for low latency (vpage5).
4. Others
•Equipped with a ducking function that attenuates background
sounds during microphone operation (vpage10).
•Supplied with DJ software.
Cautions on handling
•Before turning the power switch on
Check once again that all connections are correct and that there are
no problems with the connection cables.
•Power is supplied to some of the circuitry even when the unit is
set to the standby mode. When going on vacation or leaving home
for long periods of time, be sure to unplug the power cord from the
power outlet.
•About condensation
If there is a major difference in temperature between the inside of
the unit and the surroundings, condensation (dew) may form on
the operating parts inside the unit, causing the unit not to operate
properly.
If this happens, let the unit sit for an hour or two with the power
turned off and wait until there is little difference in temperature
before using the unit.
•Cautions on using mobile phones
Using a mobile phone near this unit may result in noise. If that
occurs, move the mobile phone away from this unit when it is in use.
•Moving the unit
Turn off the power and unplug the power cord from the power
outlet. Next, disconnect the connection cables to other system units
before moving the unit.
•About care
•Wipe the cabinet and control panel clean with a soft cloth.
•Follow the instructions when using a chemical cleaner.
•Benzene, paint thinner or other organic solvents as well as
insecticide may cause material changes and discoloration if brought
into contact with the unit, and should therefore not be used.
About this manual
n Symbols
v
This symbol indicates a reference page on
which related information is described.
This symbol indicates a supplementary
information and tips for operations.
NOTE
This symbol indicates points to remember
operations or function limitations.
n Illustrations
Note that the illustrations in these instructions are for explanation
purposes and may differ from the actual unit.