E0
W9
W8
W6
W5
W3
W2
W1
W4
W7
q Beats select knob (BEATS)
Rotate the knob to select the effect beats.
•Press this button for more than 1 second while
holding down Q0 SHIFT to return the beat
settings to the default value.
w Tap button (TAP)
Sets the BPM value used for the effects. Press
this button repeatedly to measure the BPM
value from the interval between presses.
e Effect adjustment knob
Adjusts the effect balance.
r Effects ON/OFF switching button
Switches the effects ON/OFF.
•Hold down Q0 SHIFT and press this button to
select an effect for the slot.
t Channel assign ON / OFF switching button
(CH ASSIGN 1/2/3/4)
y Loop point setting button (IN/OUT) ········· (15)
Sets the loop in point and loop out point.
•Press this button during a loop to make fine
adjustments (trimming) to the loop points
using the jog wheel.
u Auto loop/loop size adjustment buttons
(AUTO LOOP, –/+) ······································ (15)
•AUTO LOOP switches auto loop ON/OFF.
•Use –/+toadjusttheloopsize.
i Hot cue button (HOT CUE 1/2/3/4) ·········· (15)
The following operations differ depending on
whether Q2 SAMPLE are ON or OFF.
•OFF: Sets HOT CUE 1 – 4 points or cue
playback.
•Hold down Q0 SHIFT and press this button to
delete each of the cue point settings.
•ON: Plays back the sample slot. If the sample
is currently being played, playback is started
again from the start of the sample.
•Hold down Q0 SHIFT and press this button to
stop playing the sample slot.
o Deck switching button (DECK) ·················· (12)
Q0 Shift button (SHIFT) ······················· (13, 15, 16)
Top panel
To Next Page
Loading...
Need help?
General
Weight and Dimensions
