Denon MC7000 - Roll Mode

21
Roll Mode
Note: The pad layouts here match the software’s default Auto-Loop time division layout. If you
shift the range of time divisions displayed in the software, the pad layout will change to match it.
In Roll Mode, each pad triggers a momentary Loop Roll.
To enter Roll Mode, press Roll / Saved Loop so that it lights aqua.
To trigger a Loop Roll, press the corresponding pad.
To shift the Loop Roll left or right, use the / buttons.
To immediately activate a 4-bar or 8-bar auto-loop, press and hold Shift and then press
the  or  button, respectively.
When the Beat Jump controls are shown in Serato DJ, Pads 5–8 (the bottom row) will let you Beat
Jump or adjust the Beat Jump Range. See the Serato DJ manual to learn more about Beat Jump.
To trigger a Loop Roll, press the corresponding pad (1–4).
To perform a backward or forward Beat Jump, press Pad 5 or 8, respectively.
To select the previous or next Beat Jump value, press Pad 6 or 7, respectively.
To shift a Loop Roll left or right, use the / buttons.
To immediately activate a 4-bar or 8-bar auto-loop, press and hold Shift and then press
the  or  button, respectively.
1/8-beat
Loop Roll
1/4-beat
Loop Roll
1/2-beat
Loop Roll
1-beat
Loop Roll
2-beat
Loop Roll
4-beat
Loop Roll
8-beat
Loop Roll
16-beat
Loop Roll
1/8-beat
Loop Roll
1/4-beat
Loop Roll
1/2-beat
Loop Roll
1-beat
Loop Roll
Beat Jump
<<
Beat Jump
Range <<
Beat Jump
Range >>
Beat Jump
>>