22
Saved Loop Mode
In Saved Loop Mode, each pad will return the track to one of your saved loops.
To enter Saved Loop Mode, press Roll / Saved Loop so that it lights yellow.
To create a loop, press and hold Shift and press X1/2 / Loop In to set the Loop In point. Then,
press and hold Shift and press X2 / Loop Out to set the Loop Out point and trigger the loop.
To save a loop, while a loop is active, press an unlit pad (unlit pads do not have loops assigned
to them). You can do this regardless of how the loop was created (Saved Loop Mode, Auto-
Loop, etc.).
To activate or deactivate a saved loop, press the corresponding lit pad.
To immediately activate and trigger a saved loop, press and hold Shift and press the
corresponding lit pad.
To delete a saved loop, press and hold Shift and press the corresponding pad.
To halve or double the length of a loop, press X1/2 or X2, respectively.
To shift a loop backward or forward, use the / buttons.
To immediately activate a 4-bar or 8-bar auto-loop, press and hold Shift and then press
the or button, respectively.
Loop 1
Loop 2
Loop 3
Loop 4
Loop 5
Loop 6
Loop 7
Loop 8
To Next Page
Loading...
Need help?
General
Weight and Dimensions
