7
2.2.4. Maintenance and Inspection
• Before conducting maintenance/inspection, parts replacement, or other operations
on the product, completely shut down the power supply. At this time, take the
following measures:
1. Display a sign that reads, “WORK IN PROGRESS. DO NOT TURN ON
POWER” at a conspicuous place, in order to prevent a person other than the
operator from accidentally turning on the power while the operation is working.
2. When two or more operators are to perform maintenance/inspection together,
always call out every time the power is turned on/off or a moving part is moved
in order to ensure safety.
• Perform inspection or maintenance work with a thorough understanding of the
specific tasks. Insufficient maintenance/inspection by the user may result in reduction
of service life of the moving parts and malfunction. If any abnormalities are detected,
stop the operation immediately
.
2.2.5. Disposal
Do not throw the product into fire. The product may burst or generate toxic gases.
2.3.
CAUTION
2.3.1. General
• If you are planning to use the product under a condition or environment not specified
in the catalogs or operation manual, or in an application requiring strict safety such as
aircraft facility, combustion system, entertainment machine, clean room, safety
device, or other equipment having significant impact on human life or property,
design operating ranges with ample margins from the ratings and design
specifications, or provide sufficient safety measures such as fail-safes. Whatever you
do, always consult us.
• Always use the cable supplied with the product for connection between the electric
gripper and electric gripper control board.
• Use DENSO WAVE genuine products for main components such as electric gripper,
electric gripper control board.
2.3.2. Working Environment
• Provide sufficient space when performing maintenance and inspection safely.
To Next Page
Loading...
Need help?
General
