15
4.1.4. Storage Environment
CAUTION
The storage environment should basically conform to the installation environment. If the
controller is to be stored for an extended period of time, provide appropriate measures to
prevent dew condensation. The controller is not packed with desiccating agent, until
otherwise specified by the user. If the controller is to be stored in an environment where dew
condensation may occur, take appropriate measure to protect the entire package, or the
controller itself after unpacking it, from detrimental effects of dew condensation. The
controller can withstand an ambient temperature of up to 60
ºC for a short period. If the
controller is to be stored for over one month, keep the ambient temperature at 50
ºC or
below.
4.1.5. Installation
If the electric gripper control board is purchased individually, the customer is responsible for
installing it in the robot controller. Refer to “Expansion Board Attachment” in the “RC8
Controller Optional Device Operation Manual” for details of the installation method.
CAUTION
•
Avoid applying any impact or load to the electric gripper control board connectors.
Failure to observe this may result in damage to the baseboard inside the electric
gripper control board.
•
Avoid applying an excessive force to the connectors by forcibly pulling the cables.
•
Avoid installing the electric gripper control board in locations where it may be
exposed to oil or water.
•
Install in a stable location. Avoid installing in places subject to frequent vibrations.
•
Avoid installing the controller in the locations where ambient temperature could be
high.
To Next Page
Loading...
Need help?
General
