5
2.1.6. Maintenance and Inspection
• If the electric gripper is used integrated into a system (machine, robot, etc.), ensure
that regulations and standards for safety measures are strictly observed, and use the
product properly and safely.
• Do not disassemble and reassemble the components relating to the basic structure
of the product or its performance and function. Doing so may result in injury, electric
shock, fire, etc.
• Never cut and/or reconnect the cables supplied with the product for the purpose of
extending or shortening the cable length. Doing so may result in fire.
2.2.
WARNING
2.2.1. Operating Environment
• Do not use the product under direct sunlight or ultraviolet ray.
• Do not expose the product to radiant heat generated from a heat source.
• Use the product within the ambient temperature range of 0℃ to 40℃.
• Use the product in the place having humidity range of 35% to 85% (without dew
condensation).
• Do not use the product in an atmosphere of corrosive gases (sulfuric acid or
hydrochloric acid). Rust may form and reduce the structural strength of the product.
• Do not use the product in a place exposed to dust, iron powder. If dust enters the
product through small openings and gaps, the product may suffer damage.
• Do not use the product in a place where it may come in contact with water droplets,
cutting oil, cleansing liquid, organic solvent, and operating oil. If expected, sufficiently
protect the product with a cover or panel. Since the product has not been designed
with waterproof, water droplets or other liquid may enter the product, resulting in
product damage.
• Do not install the product in a place subject to large vibration or impact (9.8 m/s2).
Doing so may result in the malfunctioning of the product.
• Do not use the product in the place where high magnetic field may cause
electromagnetic interference. Failure to do so may result in malfunction.
• Do not use the product in the places where large current or high magnetic field is
present, welding or other operations are performed that cause arc discharge, subject
to electrostatic noise, and with potential exposure to radiation. Failure to do so may
result in malfunction.
To Next Page
Loading...
Need help?
General
