Denso RC8 - Handling the Packed Controller; Handling the Unpacked Control Board; Installation and Operation Environment

14
4.1.1. Handling the Packed Controller
CAUTION
• Do not apply excessive impact on the package by dropping or hitting.
• When setting down the package, keep it horizontal
• Do not step onto the package.
• Do not place a heavy object that can deform the package on the package or article of
a shape that allows the load to concentrate.
4.1.2. Handling the Unpacked Control board
CAUTION
• When transporting the controller, take care not to hit it against other object.
• Avoid applying excessive force to any part of the electric gripper control board.
• Never directly touch the power terminals and signal terminals.
• Take due care not to drop the control board when unpacking. Failure to observe this
may result in damage to the electric gripper control board or injury.
• Should you find any part of the control board damaged or missing during
transportation, please contact us immediately.
4.1.3. Installation and Operation Environment
CAUTION
Install the controller in an environment meeting the conditions listed below.
No.
The environment in which the controller is used must
1
Not expose the product to direct sunlight.
2
Be free from radiant heat coming from equipment that generates a large amount of
heat, such as a heat treatment furnace.
3
Have ambient temperature of 0ºC to 40ºC
4
Humidity of 85% or below (without dew condensation).
5
Be free from corrosive gas or flammable gas.
6
Be suitable for normal assembly work and free from excessive dust.
7
Be free from oil mist or cutting fluid.
8
Be free from vibrations exceeding 1.0G.
9
Be free from strong electromagnetic wave, ultraviolet light, radiation.
10
Chemical resistance is not considered in the design of the product. Be free from
chemical vapors and gases.