DERRICK HYPERPOOL SHAKER User Manual

SECTION 3 - INSTALLATION
15 Jun 12 3-1
HyperPoolShaker
GENERAL
This section describes the recommended installation procedure for the Derrick HyperPool shaker.
The equipment is shipped partially assembled to comply with shipping height restrictions.
Installation of the desilter and desander, if included, is recommended before final placement of the
equipment.
SAFETY
Read and understand ALL safety information presented in this manual before installing and
operating this equipment. Refer to Section 2 for a summary of Warnings addressing installation,
operation and maintenance of this equipment.
Before beginning the installation review the Equipment Handling Procedures in this section. In
particular, note the information concerning “lift points” and the use of spreader bars when lifting or
moving the equipment.
Failure to observe proper equipment handling procedures may result in serious personal injury
and/or damage to the equipment.
WARNING! USE SPREADER BARS TO PREVENT DAMAGE WHEN LIFTING
THE EQUIPMENT.
WARNING! TO ENSURE PROPER BALANCE AND ORIENTATION WHEN U
NIT
IS RAISED AND PREVENT DAMAGE TO COMPONENTS, ATTACH LIFTING
SLING ONLY AT DESIGNATED LIFT POINTS. DO NOT ATTEMPT LIFTING BY
ATTACHMENT TO MOTOR OR ANY OTHER LOCATION.
WARNING! BE SURE THAT HANDLING DEVICES HAVE SUFFICIENT LIFTING
CAPACITY TO SAFELY H
ANDLE THE WEIGHT OF THE EQUIPMENT.
WARNING! DO NOT REMOVE SHIPPING BRACKETS UNTIL EQUIPMENT HAS
BEEN POSITIONED AT FINAL INSTALLATION SITE.

DERRICK HYPERPOOL SHAKER Specifications

General

Brand	DERRICK
Model	HYPERPOOL SHAKER
Category	Engine
Language	English