SECTION 4 - OPERATING INSTRUCTIONS
15 Jun 12 4-1
HyperPoolShaker
GENERAL
This section includes initial and normal startup, normal shutdown, and emergency shutdown
procedures for the HyperPool shaker. Operating procedures are also included for desilter,
desander, and the adjustable while drilling (AWD) system.
OPERATING SAFETY
WARNING! MOTOR HOUSING BECOMES HOT DURING OPERATION AND
MAY CAUSE SEVERE BURNS. DO NOT TOUCH MOTOR HOUSING DURING
OPERATION
OR IMMEDIATELY AFTER MOTOR HAS BEEN OPERATING.
WARNING! ALL OPERATING AND MAINTENANCE PERSONNEL MUST READ
AND UNDERSTAND
ALL SAFETY INFORMATION IN THIS MANUAL BEFORE
WORKING WITH THE EQUIPMENT.
WARNING! BE SURE THAT ALL PERSONNEL ARE CLEAR OF MACHINE
BEFORE ADJUSTING ANGLE OF SCREEN BED.
WARNING! DO NOT ATTEMPT TO OPERATE EQUIP
MENT WITH SHIPPING
TS INSTALLED.
WARNING! BEFORE STARTING UP MACHINE, BE SURE THAT ALL
PERSONNEL ARE CLEAR
OF EQUIPMENT.
INITIAL STARTUP
Perform the Initial Startup procedure when the HyperPool shaker is being started for the first time,
following parts replacement, or when equipment has been removed from service for an extended
period. Refer to the following table for initial startup instructions.
Step Procedure
1
Confirm that all operators and maintenance personnel have read and understand all
operating and safety information in Section 2 - Safety.
2 Verify that equipment has been installed properly.
3
Check that all tools, documents, and shipping brackets have been removed and there
are no obstructions to operation, giving special attention to bed of screen frame.
4 Check that correct electric power configuration and required utilities are on site.
5 Verify that screen panels have been installed properly.
6 Start shaker in accordance with Normal Startup procedure below.
To Next Page
Loading...
Need help?
General
