OPERATING INSTRUCTIONS
4-2 15 Jun 12
HyperPoolShaker
NORMAL STARTUP
The following procedure shall be performed at each machine startup:
Step Procedure
1 Verify that all personnel are clear of shaker before applying electric power to equipment.
2 Closed fused disconnect to apply power to shaker.
2
Press green START pushbutton to apply electric power to the vibrator motors. Allow
motors to reach operating temperature (about 5 minutes).
3
Start pump or open valve to introduce flow of material to feeder or desilter / desander,
as applicable.
4
Observe pool configuration that forms on bed of screen frame, and adjust the AWD
and/or inlet flow rate, as required to achieve desired pooling on screen panels.
NORMAL SHUTDOWN
The normal shutdown procedure is to be used for controlled stopping of operation. Normal
shutdown is performed for routine activities such as cleaning, lubrication, inspection, adjustment,
or screen panel replacement.
Step Procedure
1 Divert or discontinue flow of material to shaker.
2 Allow all oversize and undersize material and liquid to discharge from screen frame.
3
Using a water hose, wash remaining material from surfaces of screen panels and edges
of screen panels where they contact sidewalls of screen frame.
4
Press red STOP button to stop vibrator motors, and open fused disconnect supplying
electric power to the machine.
5 Lock out and tag out machine.
EMERGENCY SHUTDOWN
To immediately stop the shaker in case of danger to personnel or other emergency, shut down
electric power at the supply source.
WARNING! IN CASE OF ANY DANGER TO PERSONNEL, IMMEDIATELY SHUT
DOWN ELECTRIC POWER TO THE EQUIPMENT.
To Next Page
Loading...
Need help?
General
