INSTALLATION
3-4 15 Jun 12
HyperPoolShaker
MOVING/POSITIONING THE EQUIPMENT (CONT’D)
While the HyperPool shaker is still mounted on the shipping skid, the unit may be transported on
the ground using a forklift. After the machine is removed from the shipping skid, an overhead-
lifting device is required.
Four lifting points (Figure 3-2) are attached to the lower outside corners of the machine to allow
attachment of an overhead lifting device. Lifting points are labeled “LIFT HERE ONLY”. DO NOT
attempt lifting equipment by attaching slings, or similar lifting aids, to the vibrator motors, or other
non-designated portions of the unit. Use of spreader bars is recommended.
WARNING! MOTOR CORD MAY BE DAMAGED DURING HOISTING IF
PINCHED BY LIFTING SLING. BE CERTAIN THAT MOTOR CORD IS
PROTECTED AGAINST PINCHING.
Figure 3-2. Lifting Arrangement - HyperPool Shaker
To Next Page
Loading...
Need help?
General
