32
2. Pull the seat base upwards at the rear with
one hand, while pushing the seat backrest
forwards as far as it will go.
3. Press and hold down the black seat release
knob. This pulls the pins in until you release
them back into a new grid position.
4. Move the backrest up and over the pegs,
back to the next seat position. Repeat the
process until you get to the seat depth
required.
5. Select the correct hole for the seating
position required.
6. Re-lock the backrest by moving the white
dial on the seat fully clockwise.
To make the seat depth smaller you will need to move the
backrest forward
1. Unlock the backrest by moving the white dial on the seat fully
anti-clockwise. Press down and hold the black seat release
knob. This pulls the pegs in until you release them back into a
new grid position.
2. Move the backrest up and over to the next forward seat position.
3. Select the correct hole for the seating position required.
4. Lift up the seat base.
5. Repeat process until you get to the seat depth required.
6. Select the correct hole for the seating position.
7. Re-lock the white dial fully clockwise.
To Next Page
Loading...
