33
SETTING THE TILT-IN-SPACE ANGLE
The seat angle is set using the seat
angle grid in the body base. For each
seat depth position there is a colour
coded slot within the grid. Each vertical
slot has ten seat angle holes, ve at the
back of each slot and ve at the front.
By locating the seat at the top of the grid you will achieve a level
seating position of 0°. Using the lower holes will enable you to
achieve a maximum tilt in space angle of 15°.
SETTING THE BACKREST UPRIGHT OR IN A SLIGHT RECLINE
If you use the front row the backrest position will be an upright 90°.
If you use the back row the backrest position will have a slight
recline of 97°.
Setting the headrest height
The headrest height can be adjusted by
undoing the black hand-screw, turning anti-
clockwise, whilst holding the headrest. Lift or
lower the headrest gently. Secure in place by
turning the hand-screw clockwise.
Seat is upright but tilted in
space 0 to 15°
Wizzybug in an
upright position with
no tilt-in-space
Fig 20 Adjusting the seating
Fig 19 Seat angle slots
Fig 21 Adjusting the headrest height
To Next Page
Loading...
