- 4 - 6159924330 - 08/2020
Introduction
Description
Controllers
CVI3 Essential can drive 1 hand-held cord tool.
CVI3 Function can drive 1 hand-held or 1 fixtured cord tool.
CVI3 Vision can manage 1 cord or 1 fixtured tool and 1 cordless tool. It is possible to extend the number of cordless
tools by using an ePOD.
TWINCVI3 can drive 2 cord tools in a synchronous or asynchronous mode.
CVI3 Essential 6159326950
CVI3 Function 6159326900
CVI3 Vision 6159326910
TWINCVI3 6159326970
Power cord
Area Length (m) Length (ft) Part number
Europe 2.5 8.20 6159170690
USA NEMA 5-15 2.5 8.20 6159170600
UK 2.5 8.20 6159170700
China 2.5 8.20 6159170610
List of compatible tightening tools
Most of Desoutter electric tools can be connected to CVI3 controllers.
- CVI II tools range (by using the CVI II adaptor)
- ERP nutrunners (by using the CVI II adaptor)
- ERS screwdrivers (by using the ERS / ERPHT adaptor)
- ERP high torque nutrunners are intended to be connected to CVI3 Essential / CVI3 Function / CVI3 Vision con-
troller (by using the ERS / ERPHT adaptor). It is not possible to connect this tool to a TWINCVI3 controller in syn-
chronous mode.
Contact your Desoutter representative to get more information and support.
Optional accessories
Table mounting kit 6153973995
Wall mounting kit for CVI3 Essential, CVI3 Function, CVI3
Vision
6153976315
Wall mounting kit for TWINCVI3 6158118970
ERS / ERPHT adapter 6159365370
CVI II tool adapter 6159360700
eSTOP controllers
eSTOP controllers are equipped with an additional safety system which immediately stops the tool when the emer-
gency system of the workstation is activated.
eSTOP stands for "Emergency stop".
When the eSTOP button is pushed, the tool stops immediately and the user info code "E918" is displayed on the con-
troller screen.
To Next Page
Loading...
Need help?
General
