To Next PageTo Next Page
Need help?Do you have a question about the Desoutter CVI3 and is the answer not in the manual?
Defines the intended purpose and application of the socket tray for Desoutter CVI3 controllers.
Instructions for checking the contents of the packing box upon receiving the socket tray.
Guidance on how to securely mount the socket tray to a table using M6 screws.
Lists and details of available optional accessories for the socket tray.
Provides the bottom view dimensions and layout of the socket tray.
Explains how to route the eBUS cable for daisy-chaining accessories.
Instructions for securely mounting the socket tray on a wall.
Details on connecting the socket tray to the eBUS network.
Steps for connecting the eBUS cable to the controller.
Procedure for internally centering and securing sockets in the tray.
How to set the position number for the socket tray on the eBUS cable.
Guidance on using tubes and locking parts for external socket guiding.
Instructions for reassembling the socket tray, including sealing and screw tightening.
Information on configuring the socket tray using CVIPC/CVI CONFIG software.
Procedure for labeling and describing the socket tray.
Specifies the range of HEX and TORX bits supported by the module.
Instructions for mounting the bit module onto the socket tray.
How to insert bits and adjust for heavier or lighter bits.
General