CAUSES SOLUTIONS
CAUSES SOLUTIONS
CAUSES SOLUTIONS
Check that you do not have a dierent coil selected
in the COIL menu (pg 29/30).
The headphones have not yet been paired with the
coil.
The coil’s serial number was changed inadvertently
in the headphones and the headphones are no
longer paired with the coil.
Sélect the right coil (pg 29/30).
Pair them (pg 30).
Pair them (pg 30).
The backphone is faulty.
The earpiece is faulty, for example its keypad was poorly
reconnected to the circuit after being dismounted, or the
audio contacts are faulty
Change it, it is easy to replace
(pg 31/48).
Contact your reseller or XP.
The ground balance is set too low.
Dicult ground, highly mineralised and infested.
Adjust the ground balance to 90 then try again.
Change to a dierent zone.
Ground control is too low.
Increase the ground balance level until
false signals stop.
Too many false signals when the coil is knocked
The detectors beeps on potery and "hot rocks"
CAUSES SOLUTIONS
45
There is no detection sound in the headphones despite them
being switched on (and pressing the buttons generates an audible beep)
There is no sound in the headphones when passing
over a target and pressing the buttons generates no audible beep