dS2824
dS2824 User Manual v4.12
Connecting I/O to Virtual Relays
Any of the eight digital I/O lines may be connected to a virtual relay. This gives the digital out-
put the same automation capabilities as the relays. Enter the relay number in the link box as
shown above. Any relay may be selected for an I/O.
When you have configured the I/O, wait for the “Update Pending” light to go out and press the
reset button, as new I/O modes are set on power-up.
Copyright © 2016-2021, Devantech Ltd.
All rights reserved.
www.robot-electronics.co.uk
22
To Next Page
Loading...